TFA 30.3032.10.IT Instruction Manual download pdf (Page 8)

Note: After the Temperature Station has successfully received the second transmitter,

Channel 3 will display the data measured by the internal sensor of the second dual channel

transmitter. Yet the probe data from the second transmitter will not be displayed on the

Temperature Station.

7. Once the remote temperature has been received and displayed on the Temperature

Station, the DCF time code reception is automatically started. This takes typically

between 3-5 minutes in good conditions—but may take up to 4 nights.

IMPORTANT:

•

Transmission problems will arise if the setting for additional transmitters is not

followed as described above. Should transmission problems occur, it is necessary to

remove the batteries from all units and follow the set-up from step 1.

•

If after 10 minutes, the Atomic auto-set time (DCF time) has not been received, press

the SET key to manually enter a time initially.

•

Daily DCF reception is done at 02:00 and 03:00. If the reception at 03:00 is not

successful, then at 04:00 and 05:00 and 06:00 there are other tries, until one is

successful. If the reception at 06:00 is still not successful, then the next try takes

place at 02:00 next day. (Please refer also to notes on “DCF-77 Radio Controlled

Time” and “Manual Time Setting”).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

No comments

TFA 30.3032.10.IT Instruction Manual Page 8